Type in the TCP port # (3001 should normally be used) and the press OK (the Protocol shouldn't need to be specified).Select Other from the Service selection categories. ![]() Type in the correct IP address (default IP for Daktronics' Lantronix boxes is 172.16.192.24).Open Tera Term and select the TCP/IP radio button.The location of the loopback will be determined by what serial communication method is being used. See Related Articles below.With the loopback in place (RX & TX jumpers), type some characters into to Tera Term and see if you can see what you type if you can, the loopback is passing (good signal up to that point).The default Baud Rate of 9600 and other COM port settings can be used for loopbacks (Baud Rate of 19200 is used to see incoming RTD data).Select the appropriate COM port from the drop down box and then press OK.Open Tera Term and select the Serial radio button. ![]()
0 Comments
Leave a Reply. |